Service and Maintenance
Maintenance and Repair Service of 3D metrology systems
Zebicon is certified to perform service and maintenance of GOM metrology systems.
We are your local GOM service experts, and perform on-site Maintenance Service or Repair Service on your metrology system when needed.
Service and maintenance is planned and coordinated on an ad-hoc basis, and is offered based on individual offers depending on your system configuration.
Regular support and maintenance of your GOM metrology system
Maintenance Service is a thorough service of your GOM measuring system, which we recommend is done annually.
We offer Maintenance Service on:
- ATOS Sensor Incl. PC
- ATOS ScanBox
- ATOS Plus
Our GOM service experts inspect the whole system, clean filters, and examine a variety of functions. Furthermore, every component is checked proactively to prevent damages and wear, and avoid a possible breakdown.
To heighten the operational reliability, components which are prone to wear and tear will be replaced.
Ad-hoc repair of your metrology system
If you experience a breakdown on your GOM metrology system, which cannot be fixed through a phone call, we will offer on-site Repair Service.
Repair Service will be performed by our GOM Service experts, who will repair or replace any defect component that is causing the problem.
With Zebicon as your local GOM service expert, you will be in touch with people who know you and your company.
Repair Service is performed at an hourly rate and any component costs will be added.